Week 11 - Wifi Shield is arrived !

As salam...

Post for the week 11..
Wifi Shield V2.2 is already arrived.

All the documentations that related with this wifi
are printed out.
The software of WizSmartScript is downloaded.
The wifi is ready to setting up.

The WizSmartScript Software

1st step:
I need to set the COM port, that is 11 and the baud
of 115200. Then clicked the "Start Script".
The result should be display as below by referring in the
set up document.

When the setting up is success will proceed on the
tutorial. The tutorial is also by using the WizSmartScript:

1)  Checked the COM port depends on your
    Arduino com port and also the baud must be 115200.
2)  Clicked "Wizard".

It will show this:

But for my part, it is not displayed as above.
Mine is appeared as shown in this video :

I've met Sir Zul regarding on this problem.
He also tried  by doing the same steps as I had done..
The result still error and when find the wizfi, still state
ERROR.
He said it might be the hardware problem.
Basically, this wifi need a wireless router.
But when to find the wifi module there is no
related with wifi router, it is related with
COM port Arduino only.

Sir Zul suggested, to call the person that I bought
this wifi. Informed them the problems.
Unfortunately, the person in charge is the seller not
a technician. So for me to communicate with the
techinician must be through an email. For sure,
it's complicated for me if not face to face.

Other solution, Sir Zul had a contact person with En.Azmi.
The person who are in experienced in Arduino.
The coincidence En.Azmi also sell this wifi shield V2.2
DF Robot. When Sir Zul informed him the status of
wifi and he gave a good response through the phone call.
I've decided to see him on the spot at Shah Alam.
I wish the wifi is going well. :)